JĘZYK / LANGUAGE / ЯЗЫК
ABOUT USNewsContactStudyGalleryGuideLogIn
OXIDECOR EXTRA FINE - THIN-LAYER RUST EFFECT - HOW-TO VIDEOS
MFA CLASSIC | MFA PLUS
priming
Prime absorbent (stable) substrate using MFA Classic concentrate diluted 1:3 with water. Apply primer with a wide brush, working it well into the substrate. Priming strengthens the substrate and improves adhesiveness and coverage of further coats.
Prime absorbent (weak) substrates and surfaces of old walls with MFA PLUS diluted max. 1:3 with water. Apply primer with a wide brush, working it well into the substrate. Deeply penetrating and binding the substrate, priming strengthens it, reduces excessive absorbency, and improves the coverage of further coats.

PRIMER E
quartz prime
We recommend diluting PRIMER E quartz primer with 10 – 15% of water and applying with a wide brush, according to the direction of the desired decorative coat. Created quartz coat will increase adhesiveness and facilitate application of further coats.

OXIDECOR EXTRA FINE
base coat
Stir Oxidecor Extra Fine thoroughly before applying each layer. Can be applied to smooth substrates using an INOX trowel without diluting. When applied with a paint brush, masonry brush, or by spraying, dilute with 10 – 25% of water according to the tool and application method. Apply a thin base layer (grain–thick) to a prepared substrate, covering the whole surface. The surface can be smoothed with a roller if ridges are present.

OXIDECOR EXTRA FINE
decorative coat
Oxidecor Extra Fine is ready to use and can be diluted with 10–30% of water or activating agent, according to the tool and application method. Apply Oxidecor Extra Fine to a prepared base coat. Remember to apply activating agent (described in instructions for the next layer) to large areas before the coat dries. The work should be performed in stages until the whole surface is covered. The surface can be smoothed with a roller if brush marks are present.

AKTYWATOR NEW
activating layer
Apply Aktywator New to a drying coat of Oxidecor Extra Fine using an atomiser. Keep in mind that the amount and frequency of using the atomiser depends on the drying time of the coat, the slower it dries, the more discolouration will be produced. This results from various factors such as humidity, temperature, and draughts. Do not perform work in the sun, rain, wind, and at temperatures below 0°C. The first layer should be distributed reasonably evenly over the whole surface. Before the coat dries completely, the activating agent can be applied locally in a pointwise manner to improve the corrosion effect. Leave to dry. If the effect is not satisfactory, apply another coat of Oxidecor Extra Fine.

SILOMAL
preservation
Silomal preserves coats and does not produce afterglow. Apply to the whole surface using euromal or a wide brush. Apply another layer when the first layer dries. The coat achieves its full properties 72 hours after application.
Lumicca Incolore primes and preserves the substrate. Before commencing work, dilute 1:1, max. 1:1.5 with water and stir thoroughly. Apply with a wide brush and distribute with euromal evenly, according to the direction of previously created pattern. Remove excessive preservative using a cotton cloth, in particular from pits. The work should be performed in stages until the whole surface is covered.

OXIDECOR EXTRA FINE
Whole system
Intended for creating special decorative effects thanks to fine-grained metal particles. Enables you to create a perfectly smooth surface both indoors and outdoors. Why is it different from Oxidecor E? It can be sprayed or applied with a trowel or a brush to all types of substrate, such as: walls, radiators, doors, metal, handles, plastic, wood, wood imitation, furniture boards, lamps, cars, bicycles, motorcycles, garden architecture, etc. Recommended for all kinds of surfaces: in housing and industrial construction, walls, metal, wood, wood imitation, plastic, furniture boards, cars, bicycles, motorcycles, lamps, garden architecture, etc

RETURN
facebook